Separation results oily water treatment

The New BilgeMaster-D series

With normal feed conditions, i.e.
solids content: < 0.1%
chloride content:< 30,000 ppm
pH: 6 - 9
and no excessive oil emulsions in the water phase, the residual oil content in the clean water discharge is 10 - 12 ppm. By varying the pump output, it is possible to even further reduce the oil content. In the case of high oil and solids contents, it is prudent to separate the bilgewater in several stages. When high emulsion fractions are present or when conveying residual oil contents below 5 ppm, it is recommended to add emulsion-breaking chemicals in the feed or to install an absorption filter in the clean water discharge.